The bumper is basically exactly as advertised. But there's a few issues that i assume are from limited prototyping.

The bumper went on with out issue, using all 6 factory mounting points. But a few things don't work as well as they could or look as good as i would like. The finish is nice, but i don't like how the side profile inlets to the factory panel, it would be better if the top chamfer carried to come closer to the stock line. And maybe wasn't dead plumb but closer to the stock line that's off by 10 degrees or so, but that's just ascetic.

But as for actual issues, the license plate lights holes are backwards. The small notch should be in the front not the back. If i had tried to install the lights they would be facing away from the vehicle not toward it. I had to use a file to open up the smaller notch, it works but isnt as tight as it should be and the oval shape of the stock light doesnt sit well in the round inset plate.

And the license plate area is not large enough. With my plate sitting on the bottom step of the bumper, the holes are about 1/4 inch too low AND the plate sits above the top of the bumper. To make it work i trimmed off about 1/4 inch off the bottom of the plate itself and about 1/8th off the top. It works BUT there is no way some one could use a license plate frame.